Roofing dumpster rental in Ankeny
Need a roll-off dumped for shingles? We drop a 10-yard container, then haul it clean the day your Ankeny crew finishes.
Roofing Tear-off Dumpster Sizing by Squares
How big a roll-off do you actually need for a roof tear-off in Ankeny? Most homeowners prefer a 20-yard container: it provides enough room for standard asphalt shingles; we use a low-wall roll-off to make loading easier. Keep in mind this simple rule: one square of shingles equals two-thirds of a cubic yard before calculating total tonnage.
15-Yard Roofing Dumpster
- Capacity: 15 cubic yards
- Fits: 15–20 squares of asphalt shingle
- Best for: Single-layer ranch and bungalow tear-offs
This 10-yard can fits a tight driveway for small tear-offs while keeping shingle weight under our single haul tonnage.
20-Yard Roofing Dumpster
- Capacity: 20 cubic yards
- Fits: 25–30 squares of asphalt shingle
- Best for: Most two-story residential tear-offs
The 20-Yard Container serves as a roofing workhorse because low side walls let crews ground-throw shingles directly into it.
30-Yard Roofing Dumpster
- Capacity: 30 cubic yards
- Fits: 35–45 squares of asphalt shingle
- Best for: Multi-layer tear-offs and small commercial roofs
A 30-Yard Container handles big roof tear-offs without a second haul-out—no overage fees on shingles in Ankeny, Iowa.
Asphalt Shingle Weight and Tonnage Planning
The three-tab shingle averages 250 pounds per square; architectural laminate runs closer to 400. Roofers route a 25-square tear-off between three and five tons before underlayment, well above a hooklift truck’s weight limit. How does that translate to a 10-yard? A roofing dumpster’s lower side walls keep that tonnage inside the haul-out cap for a single pickup.
When you mix shingle debris with framing or sheathing offcuts, we route the container to our general C&D debris service—keeping your asphalt-only roof tear-offs separate ensures the load stays clean. This simple process keeps your cleanup moving forward efficiently.
Driveway Placement for Roofing Crew Workflow
We angle the Roll-Off container so the swing-door faces your eave, allowing crews to ground-throw shingles directly into the bin. Before the rollers touch concrete in Ankeny, we place driveway boards underneath the steel frame to prevent surface damage. Following our roof tear-off container sizing guidelines ensures a six-foot tarp perimeter for a clean nail sweep. Consult this asphalt shingle disposal best practices guide to manage debris responsibly while keeping your driveway unscarred.
Drop angle
Rear door toward the roof line
Set the swing-door end facing the eave your crew is working to align walk-in loading and ground-throw in one path.
Surface protection
Wooden planks under every roller
Loaded shingle weight can gouge concrete; driveway boards stay under the rear rollers for the full rental window.
Sweep zone
Six-foot tarp perimeter
Stage magnetic sweepers on the tarp side so nail cleanup can run in parallel with your loading process.
Tile, Slate, and Metal Roof Tear-off Containers
Concrete tile, natural slate, and standing-seam metal punish a container that was not built for the density; therefore, we route a reinforced 30-yard bin for these heavy tear-offs. This low-wall unit features a heavier floor plate and thick ribbed sides: we cap the fill volume well below the visual rim to keep axle weight legal. We use a lowboy to set the unit; for mixed loads, ask about our general construction debris service.
Same-day Pickup for Fast Roof Project Turnover
Tear-offs run on tight schedules; the roll-off shouldn’t be the bottleneck. Dispatch coordinates same-day haul-out within the crew’s demobilization window so the container frees up for inspection; gutter reinstall happens clean. We route the swap-out straight to Polk County jobs, leaving the driveway clear for the homeowner before the crew departs!